In the case of the "Top Opening" the reference lines will be aligned with the top and bottom of the wall. Make sure to center them on the wall and are flush to the bottom. Use the "Skittles ISO" PDF to see where each one goes. Use spray adhesive to adhere each profile to the appropriate wall. To finish the the cutting, print out the different ". Using a 13/32" drill bit on a drill press, 7/16" can be used, drill to a depth of 2-3/4". To drill this out, clamp a scrap piece, cut to the same height, to the side where the slot will be. The front wall will have an opening for the top to sit in assisting with spinning the top. If you choose to use dado's, cut them to a depth of 1/4" as shown in the drawing. With all that in mind, use the measurements from the "Skittles Shop Drawing" PDF to cut out the base and walls of the game. Some measurements might have to change to accommodate the difference in thickness. 1/2" material can be used for the walls to lighten the whole game. 3/4" material was used to make the walls.If you have a dado stack and choose to use it, make sure to add a 1/2" to the lengths of the pieces that sit in a dado.This is important because the top you will make later will move around the whole area smoothly and not stay in a low spot. If I were to do this again I would use a hardwood plywood because the wood would stay flat better then the MDF when exposed to humidity changes. I built this out of MDF because thats what I had on hand.pdf in step 2.Ī few notes before you start cutting out all the pieces using the provided PDFs: I knew even these measurements weren't going to be 100% accurate so I used the plans from and my measurements to come up with what I believe to be fairly accurate dimensions which I have as a. I ended up using software that allowed me to calibrate a known distance on a picture then measure everything else. This company I believe had the original design for this game.ĭespite a long search I was unable to find any plans for Merdel's/Carrom's design. As I have mentioned earlier, the one I played was done by Merdel.Īs a side note, Merdel started in1961 from a few employees leaving another game company called Carrom. They do have plans for a version of this game but it is not quite the one I grew up with. As it says on the box it is "The Exciting Spin Top Bowling Game." I got a quick simple history of this game from where they describe this game as an old English pub game. I remember as a child going to my grandparents home and playing a vintage game called Skittles made by the company Merdel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |